![]() Use a multi-tool or pliers to bend each exposed wire into a round hook. STEP 6: Connect the wires to the new switch. Remember to leave about a half-inch of wire exposed on each length.īecause electrical wires experience stress over time and can weaken with usage, you must ensure that when the wires are reattached to the replacement switch, any portion of the wire that makes contact with the screws is undamaged. Clip off any degraded portions with a multi-tool or wire cutters. ![]() STEP 5: Check the wires for any signs of damage.Įxamine the ends of the wires for evidence of fraying. If it makes your job any easier, go ahead and bend the dangling wires out of the way. At this point, you should be able to remove the switch from the wall. Once done, free the terminal wires, using pliers if necessary, to undo a tight coil. Loosen the screws holding the terminal wires in place. Ground wires STEP 4: Disconnect the terminal and ground wires. These are ground wires.Īll three wires will connect in a single wire nut, and the shortest one will connect to a green screw on the light switch.ġ.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |